NON-DESTRUCTIVE CONTROLS ON MATERIALS
SAFAS produces every single cast under a quality guarantee regime. Each of our products is critically important and is meticulously inspected to verify its integrity and compliance with current regulations. Quality controls on products are conducted in compliance with international standards through rigorous internal procedures prepared according to customer requests.
The quality assurance system used is recognized by the most important national and foreign companies and is based on the use of the most technologically advanced measuring equipment, regularly subjected to calibration procedures.
MT inspection
Magnetic inspection with dry, wet, or wet fluorescent method in controlled conditions of environment brightness
Magnaflux Limited 6,000 Amp and 10,000 Amp, for examination with dry and wet magnetic powders, fluorescent in Wood’s lamp
Multidirectional Kriope
UT inspection
Ultrasound with analog Krautkramer Usip 11 and digital computerized Krautkramer Usn 60 with straight, angled, focused probes
LP inspection
Use of contrast and fluorescent penetrating liquids, according to European and American standards. Nuclear certification of products used in controlled conditions of environment brightness
RX inspection
Radiographic testing: X-rays with Seifert 200Kv equipment and in radiographic bunker with Linatron M9A Dual Energy linear accelerator of 9 ÷ 5 Mev; gamma rays with 2 IR 196 sources and 1 Co 60 source
VT inpection
Visual inspection of the castings by our second and third level technicians